After you generate an output expression:
| 1. | click the output |
| 2. | click one or more of the Output Show. . . check boxes to apply them to the selected expression |
Show Intermediate Variables - if the system uses intermediate variables, their definitions are displayed in the output window.
Show Name - is a term assigned by the system to the output. This name is zn, where n is the sequential number of the output .
Show On Diagram - puts the output expression on the diagram when checked.
Show in Output Window - puts the output expression in the Output Window when checked.
Too Big for Diagram - indicates when the output expression is too big for the diagram window, according to the setting of the slider below.
Maximum Size Allowed On Diagram - slider sets the threshold for the size of expression for all output that appears on the diagram.
| • | Setting the slider to the extreme left (Small) gives the same result as unchecking the Show on Diagram box and will not place the output in the Diagram Window, but in the Output window. |
| • | Setting the slider to the extreme right (Large) will always show the output in the Diagram Window. |